新闻资讯

首页>>新闻资讯 >

臂是对挖掘机质量的一次检验

日期:2018-04-03   来源:http://www.dyqicheng.com/
机械化程度高,需要劳动力少,施工组织简单;施工效率高,工程进度快加长后的臂对挖掘机质量要求比较严格,也可以说臂是对挖掘机质量的一次检验,在动作过程中不易离析,因此容易保证工程质量
 
  The high degree of mechanization requires less labor, simple construction organization, high construction efficiency, the arm is more stringent on the quality of the excavator after the construction of the project, and it can also be said that the arm is a test for the quality of the excavator, and it is not easy to segregate in the action process, so it is easy to guarantee the quality of the project.
 
  作业安全,可减少施工过程中的危险;对施工作业面的适应性强,作业范围广,挖掘机加长臂可以铺设到其他难以到达的地方,满足各种施工要求;在正常工作条件下,挖掘机加长臂不会污染环境,符合环保要求。
 
  The safety of the operation can reduce the danger in the construction process; it has a strong adaptability to the construction work surface and a wide range of operation. The excavator can lay the long arm of the excavator to other difficult places to reach the construction requirements. Under normal working conditions, the excavator will not pollute the environment with the long arm and meet the environmental requirements.
加长臂挖掘机租赁大臂与小臂无法抬起跟外伸,此故障基本上是大臂跟小臂的曲轴传感器损坏,此传感器功能相当于一个普通电位器,用于感知工作臂的角度,防止过度操作发生倾翻或碰撞
 
  The long arm excavator leases the arms and arms that can't be lifted and extended. This fault is basically damaged by the crankshaft sensor of the big arm and the small arm. This sensor function is equivalent to a common potentiometer, used to perceive the angle of the working arm and prevent overturn or collision from overoperation.
 
  加长臂挖掘机租赁大臂与小臂无法抬起跟外伸,此故障基本上是大臂跟小臂的曲轴传感器损坏,此传感器功能相当于一个普通电位器,用于感知工作臂的角度,防止过如果传感器出现故障或线路搭铁短路有问题,就会引起上述故障的出现,这个传感器不易购买,解决方法是用两只电阻来代替传感器同样可以使挖掘机能正常工作,不过会失去保护功能。
 
  The long arm excavator can not lift and extend the arm and the arm. This fault is basically the damage of the crankshaft sensor of the big arm and the small arm. This sensor function is equivalent to a common potentiometer. It is used to perceive the angle of the working arm and prevents the occurrence of the above failure if the sensor fails or the circuit lap short circuit has a problem. This sensor is not easy to buy and solve. The solution is to use two resistors instead of sensors, so that the excavator can work normally, but it will lose its protection function.
 
  如果传感器出现故障或线路搭铁短路有问题,就会引起上述故障的出现,这个传感器不易购买,解决方法是用两只电阻来代替传感器同样可以使挖掘机能正常工作,不过会失去保护功能。
 
  If the sensor fails or the circuit lap short circuit has a problem, it will cause the emergence of the above fault, the sensor is not easy to purchase, the solution is to use two resistors to replace the sensor can also make the excavator work normally, but will lose the protection function.
 
 
 
 
 
 

【本站图片均由网站所有方提供,部分图片来源于网络,如无意中侵犯了某媒体或个人的知识产权,请来信或来电告之,本网站将立即删除。】